Transcend 2 GB SD Flash Memory Card (TS2GSDC)

May 15, 2018 - Comment

Transcend Secure Digital Cards are suitable for use in a wide variety of devices including, digital cameras, mobile phones, PDAs, MP3 Players, notebook computers and other electronic devices. Product Features It supports auto-standby, power-off and sleep modes It allows In System Programming (ISP) for updating firmware Easy to use, plug-and-play operation Conforms to the Secure

Buy Now! $6.25Amazon.com Price
(as of 04/20/2020 6:19 am GMT-0500 - Details)

Transcend Secure Digital Cards are suitable for use in a wide variety of devices including, digital cameras, mobile phones, PDAs, MP3 Players, notebook computers and other electronic devices.

Product Features

  • It supports auto-standby, power-off and sleep modes
  • It allows In System Programming (ISP) for updating firmware
  • Easy to use, plug-and-play operation
  • Conforms to the Secure Digital Card interface standard
  • Built-in Error Correcting Code (ECC) to detect and correct transfer errors
  • 2G SD Card

Comments

Natoscia Sommer says:

Great card, price could be slightly lower Ok, so you can buy a 16-32 gb SD Card online for right around $20 right? Why in the world would you buy this 2gb card for $7? Well, there are several reasons. Many laptops and cameras from the early 2000s had capacity limits which made having anything over a set limit useless. For example, if you had a digital camera that had an SD card slot and the manual said that it supports up to 4gb SD cards, but you bought and installed an 8gb card, then the camera would only recognize the first 4gb, so…

Jimmy says:

Transcend 2GB Bough this SD card because I have an older radio Jensen 5112 and no other SD Card I had worked. I later looked up online that the SD Card needed to be 2GB or smaller to work. Since it is very hard to find 4GB, 2GB, or 1GB SD cards at most stores, I tried this Transcend SD Card and it works great. Please note that if you are looking for an SD card this small you are probably doing it for a very specific reason or using older equipment with it. Please note if you are using this with older…

Stasya says:

Perfect for use with Makerbot Replicator 2.0 I use this for my Makerbot Replicator 2.0. When my SD card went bad, I did some research and found out that Makerbot is finicky about which SD cards it likes. One guy on a blog said the Transcent 2GB SD Flash Memory Card (TS2GSDC) was the only SD card that worked straight out of the package. Sure enough, I pulled it out of the package, loaded a print file on there, stuck it in the printer, and Voila! It printed just fine. No fuss, no problems. I’ve been using it almost daily since I purchased…

Comments are disabled for this post.